PDA

View Full Version : Warrior rear drop outs



HHHH
02-07-2019, 12:40 AM
Not exactly a jig, but made a mock-up of the drop outs using the 3d printer.

Was used to mark out the metal for cutting.

The two pieces of metal could then be bolted to the mock-up, using the spindle hole (pre drilled).
Finishing could then take place, by removing metal up the the 3d print, makes a change from the "line" I suppose.
Obviously, being plastic too much heat will damage it if a grinder was being used.

http://i67.tinypic.com/20ixshy.jpg


http://i63.tinypic.com/jq2wap.jpg

Radical Brad
02-07-2019, 08:05 PM
A handy tool to have!
One day it would be nice to be able to print out a full fairing.

Brad